User's Manual

AUTEC - Dynamic Series
Operation 27
LIDYNE00-07
6.3 Power keyswitch
The transmitting unit have a power keyswitch. It can either be:
- mechanical key (see paragraph 6.3.1)
- Key ID 0-1 (see paragraph 6.3.2).
6.3.1 Mechanical key
The mechanical key makes it possible to power the transmitting unit. When the mechanical
key is required to be used in a transmitting unit, the radio remote control cannot work if it
is not inserted.
When is required the mechanical key is always required the "ID internal tx memory".
6.3.2 Key ID 0-1
The "Key ID 0-1" makes it possible to power the transmitting unit.
It stores the radio remote control's address. Therefore, the "Key ID 0-1" can only be used
in the transmitting unit belonging to its related radio remote control: when the transmitting
unit requires the "Key ID 0-1", the radio remote control cannot work if it is not inserted. The
technical data sheet indicates if the "Key ID 0-1" is required.
As the radio remote control address is stored in the "Key ID 0-1", use it with utmost care to
reduce risks that may result from incorrect handling.
When is required the "Key ID 0-1" it can't be required also the "ID internal tx memory".
6.3.3 power keyswitch insertion
Perform the following operations to insert the power keyswitch:
1. push the power keyswitch inside the corresponding housing
2. rotate the power keyswitch clockwise.
6.3.4 power keyswitch removal
Perform the following operations to remove the power keyswitch:
3. rotate the power keyswitch anticlockwise
4. pull the power keyswitch to remove it from the corresponding housing.