User's Manual
AUTEC - Dynamic Series
Frequencies 3
LIDY2E00-08
1.1 Federal Communications Commission (FCC)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
1.2 Industry Canada (IC)
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device..
2 Frequencies
The radio link between the units of Autec Dynamic series radio remote controls is established
at one of the frequencies permitted by the US, Canadian and Australian standards in force
when the system is put on the market.
Frequency band ............................................................................................ 915-928MHz
RF power ........................................................................ meets FCC and IC requirements
Available radio channels .............................................................................................. 259
Channel spacing ...................................................................................................... 50kHz
Dynamic series industrial radio remote controls communicate either in dynamic or static
mode. Mode is set by the machine manufacturer.
2.1 Dynamic mode
A radio remote control communicating in dynamic mode:
- uses a working frequency in the band 915-928MHz
- checks that the frequency is free before using it
- continually changes the working frequency to maintain the radio link even when interference
occurs.
2.2 Static mode
A radio remote control communicating in static mode:
- uses a working frequency in the band 915-928MHz
- checks that the frequency is free before using it
- always works at the same frequency until the stop function is activated.