User's Manual
Table Of Contents
- LIUDYN2AC0-00.pdf
- Index
- 1 User manual
- 2 Documentation
- 3 Dynamic series description
- 4 Risk analysis
- 5 FJS transmitting unit
- 6 FJL transmitting unit
- 7 FJM transmitting unit
- 8 ARM receiving unit
- 9 Warnings
- 10 Radio remote control lifecycle
- 11 General operating instructions
- 12 Working
- 13 Values of proportional outputs
- 14 Data memory backup
- 15 Troubleshooting
Working
Wire control
AUTEC - Dynamic Series
LIUDYN2AC0-00_eng.fm User manual
43
When using the wire control, the working features do not change (i.e. the mean-
ing of actuators and the Data Feedback function).
12.7.2 Working
Before starting to work, make sure that the cable and the corresponding connec-
tors are intact.
The wire control can only be connected and disconnected when the transmitting
unit is switched off.
After connecting or disconnecting the wire control, start up the radio remote con-
trol (see paragraph 11.1) to control the machine.
During operation with wire control:
- radio link is off
- leave the battery inside the transmitting unit, even though the power supply
comes from the receiving unit.
The battery is not, in any case, recharged through the wire control: it can only
be recharged through its appropriate battery charger provided together with
the system.
When you finish working with the cable control, disconnect the cable from the
transmitting unit and from the machine, and protect the connectors on the units
with their caps.