User's Manual

2
E16STXUS1 guide
In order to work correctly, the following DIP switches in the transmitting module E16STXUS1
and in the receiving module E16SRXUS1 of the radio remote control units must be set in the
same way.
3 Frequency table
4 Antenna position
The position of the E16STXUS1 antenna depends on the transmitting unit: the antenna can be
folded to fit the space inside the transmitting unit but it must never be unsoldered from the
module.
5Installation
Autec maintains control of the assembly of the E61STXUS1 modules into the its transmitting
units.
It is forbidden any other type of use or installation by anyone.
6Replacement
It is possible replace the E16STXUS1 transmitting module in the transmitting unit only by
authorized personell which knows the procedure related to the specific transmitting unit.
7IC warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is sub-
ject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device.
MODULE DIP
E16STXUS1
(group of 8 DIP
switches)
2345678
E16SRXUS1
(group of 8 DIP
switches)
2345678