Instruction Manual

LIUFJQ001_eng-00AUTEC
37
11 Malfunction signalled by the Transmitting Unit
The table below li󰘵s malfunctions that are signalled by LEDs on the Transmitting Unit and the
solution to those malfunctions.
If the problem persi󰘵s after attempting the sugge󰘵ed solution, contact the support service of
the Machine Manufacturer.
Signals Possible reasons Solutions
The green LED blinks fa󰘵.
The red LED blinks for 3.5
minutes.
The battery is not charged
enough or the Transmitting Unit
has been on for eight hours.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7) or it is necessary
to switch off the Transmitting Unit
and to re-󰘵art the Radio Remote
Control.
The green LED blinks slowly.
The red LED blinks for 3.5
minutes.
The green LED is off.
The red LED emits one very long
blink.
The Transmitting Unit does not
work correctly.
Perform the address 󰘵orage
procedure (see paragraph
8.16.1).
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED emits one long blink.
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED emits two long blinks.
At lea󰘵 one of the actuators
corresponding to commands
D2-D20 and SAFETY is
activated.
Bring the actuators to the re󰘵
position.
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED emits three long blinks.
The battery is very low.
It is necessary to replace the
battery with a charged one (see
paragraph 8.7).
At Radio Remote Control 󰘵art
up, the green LED is off and the
red LED emits four long blinks.
At lea󰘵 one of the actuators
corresponding to commands
A1-A8, H1-H8 and L1-L8 is
activated.
Bring the actuators to the re󰘵
position.
Whenever the red LED illuminates, the acou󰘵ic signal device activates.
The Transmitting Unit switches off 3.5 minutes after the red LED has been blinking
fa󰘵.
12 Decommissioning and disposal
Instructions for correct decommissioning and disposal of Radio Remote Controls are described
in chapter "Decommissioning and disposal" in "Part A" of the Instruction Manual. Therefore,
please refer to that part of the Manual.