Instruction Manual

If the Transmitting Unit has a "Key ID 0-1", always store it in a safe place
each time it is removed. If this key is lost, the Radio Remote Control cannot
work, since the Transmitting Unit needs the address stored in the key to
work with its Receiving Unit.
FAILURE TO DO SO CAN RESULT IN SERIOUS BODILY INJURY OR DEATH
AND/OR PROPERTY DAMAGE.
8.3 Operational use
The use of Radio Remote Controls is strictly limited to properly trained Personnel.
When the Radio Remote Control is installed on Machines on board vehicles,
switch o󰓐 the Receiving Unit while the vehicle is travelling.
All instructions for correct use are given in "Part C" of the Manual (related to the Transmitting
Unit).
Environmental working conditions are given in the following table.
Temperature Relative Humidity Air pressure
Use
of the
Transmitting
Unit
-25°C to +55°C
(from -13°F to +130°F)
e
from 5% to 95%
f
from 70kPa to 106kPa
f
Use
of the Receiving
Unit
-25°C to +70°C
g
from -13% to +158%
f
e. Class 5K4H of standard EN50178.
f. Class 5K2 of standard EN50178.
g. The Receiving Unit can work at 70°C (185°F) only if the sum of currents corresponding to the
loads simultaneously activated by digital and analogue outputs does not exceed 10A.
44
LIUDYN002_eng-01
Instructions for the User
AUTEC - Dynamic Series