Instruction Manual

4.3 Technical data
Command response time .................................................................................... 80-130ms
Active stop time ..................................................................................................... <130ms
(Max.) active stop time ............................................................................................ 200ms
Passive stop time
a
....................................................................................................... 0.5s
Hamming distance ....................................................................................................... ≥15
Probability of undetected error ................................................................................. <10
-15
Typical working range ................................................................................... 100m (330ft)
Working range with Low Power function .......................................................... 30m (100ft)
Performance Level of safety functions according to EN ISO 13849-1 / EN IEC 62061:
Stop protection ......................................................................... PL e / SIL 3 (4-wire wiring)
.................................................................................................. PL d / SIL 2 (2-wire wiring)
Protection against unintended movements from the standstill position (UMFS) PL d / SIL 2
a. The passive stop time may be set at 1.2s or 2s if it is established by the Machine Manufacturer:
the User must check the Radio Remote Control's stop time in the data provided in the Technical
Data Sheet or in the instruction manual by the Machine Manufacturer.
The technical data related to the single Units belonging to the Dynamic series are provided
in the speci󰘰c parts of the Manual and in their Technical Data Sheet.
4.4 Identifying the Radio Remote Control
A serial number (S/N) univocally identi󰘰es each Radio Remote Control.
The serial number is provided in the identi󰘰cation plate on each Radio Remote Control Unit.
This is the only reference to be used for maintenance operations and for any other situation
when you need to precisely identify the Radio Remote Control.
The serial number must be mentioned in any communication with Autec, its dealers, Installers,
Maintenance Technicians of the Radio Remote Control and with the people who, in any
capacity, need information, spare parts or technical data concerning the Radio Remote Control.
Plates on the Units must not be:
- removed from their position (removal voids the warranty),
- altered or damaged (contact Autec for replacement).
AUTEC - Dynamic Series
Radio Remote Control features 25
LIUDYN002_eng-01