User's Manual
14
LIUDT1003_eng-00
Frequencies
AUTEC - Dynamic Plus series
4 Frequencies
Dynamic Plus series' Radio Remote Controls can work in two dierent frequency bands:
863-870MHz or 915-928MHz.
The Radio Remote Controls' working frequency is dened by market-specic laws
and standards. In order for the system “Machine+Radio Remote Control” to be
compliant and therefore to be used, these laws and standards must be respected:
if they are not, the Radio Remote Control cannot and must not be used.
Autec cannot be held responsible if the Radio Remote Control is set with
frequencies that are forbidden in the country of use.
4.1 863-870MHz frequency band
4.1.1 Frequencies
The radio link between the Units of Autec Dynamic Plus series Radio Remote Controls is
established at one of the frequencies permitted by the European standards in force when
the system is put on the market.
Frequencies used ........................................................................................................ 128
RF power ...................................................................................................... <25mW ERP
Channel spacing ...................................................................................................... 50kHz
The Units communicate with one another in dynamic mode, that is:
- they use a working frequency in the 863-870MHz band,
- they check that the frequency is free before using it,
- they continually change the working frequency to maintain the radio link even when
interference occurs.
4.1.2 Countries of usage
Dynamic Plus series' Radio Remote Controls working in the 863-870MHz frequency band can
be used within the EU (European Union) and the EFTA (European Free Trade Association).
Check on the technical data plate of the Units in which markets the Radio Remote Control
can be used.