User's Manual
48
LIUDTH000_eng-00
Troubleshooting
AUTEC - Dynamic Plus series
10 Troubleshooting
If the Radio Remote Control does not work correctly, carry out the following preliminary checks:
- Move all other Transmitting Units in the working area away from the Autec Transmitting
Unit in use to avoid possible radio interference.
- Bring the Autec Transmitting Unit closer to the matching Autec Receiving Unit to avoid
possible radio interference, always positioning yourself in a safe place and with full view
of the Machine, its operational area and the load, if any.
- Determine if the problem lies with the Radio Remote Control or with the Machine: to that
purpose, you need to try to control the Machine with another control station (if any),dierent
from the Radio Remote Control. If the problem persists after this attempt, you need to x
the Machine: follow the instructions provided by the Machine Manufacturer. Otherwise,
the problem lies with the Autec Radio Remote Control, so you need to carry out further
checks (see paragraph 10.3).
10.1 Radio Remote Controls with "Data Feedback" function
It is still possible that the Transmitting Unit sends commands to control the Machine even
if the Data Feedback function does not work properly (refer to "Data Feedback function" in
"Part C" of the Manual), or if there is no information and/or signals coming from it.
When the display or the LED array does not work, please contact the support
service of the Machine Manufacturer, even if none of the problems indicated
in paragraph 10.3 has been detected.
10.2 Radio Remote Controls with cable control
Possibly use the wire control to check if radio interference occurs.
On the contrary, if you want to check that the wire control works properly:
- connect the cable to the Transmitting Unit and to the Receiving Unit,
- check that the movement carried out by the Machine correspond to the commands sent
by the Transmitting Unit.
10.3 Solutions in case of malfunction
Look up in “Part C” and/or in “Part D” of the Manual to identify the Radio Remote Control
malfunction signalled by light signals on the Units.
If the problem persists after attempting the suggested solution, contact the support service
of the Machine Manufacturer.