User's Manual
AUTEC - Dynamic Plus series
Installation 31
LIUDTH000_eng-00
6.4.4 Wiring
Wiring is understood as the electrical cable connections that can be found:
- inside the Receiving Unit,
- between the Receiving Unit and the Machine.
ALL ELECTRICAL CONNECTIONS MUST BE PERFORMED AND MADE IN
COMPLIANCE WITH THE NATIONAL ELECTRIC CODE AND ALL APPLICABLE
LAWS, REGULATIONS AND STANDARDS, EVEN LOCAL. IF INSTRUCTIONS
PROVIDED BY AUTEC ARE INCONSISTENT WITH SUCH APPLICABLE LAWS,
REGULATIONS OR STANDARDS, DO NOT INSTALL THE AUTEC RADIO
REMOTE CONTROL WITHOUT CONSULTATION WITH AUTEC. AUTEC IS
NOT RESPONSIBLE FOR AND SHALL NOT BE HELD LIABLE FOR ANY
MALFUNCTIONS OR ACCIDENTS THAT MAY OCCUR DUE TO ANY IMPROPER
INSTALLATION OR INCONSISTENCY BETWEEN ITS INSTRUCTIONS AND
SUCH LAWS, REGULATIONS OR STANDARDS.
FAILURE TO INSTALL THE AUTEC RADIO REMOTE CONTROL CORRECTLY
MAY RESULT IN PERSONAL INJURY OR DEATH, OR PROPERTY DAMAGE.
The power supply of the Receiving Unit must have a switch that allows
power supply disconnection during installation, wiring and/or maintenance
operations. Connect the Receiving Unit immediately downstream of the
Machine main switch or of the electrical panel main switch (see the Installation
Manual).
The Receiving Unit's power supply must be protected against short circuit
by means of an external device (by way of example: fuse, thermal magnetic
circuit breaker). Such device must be able to interrupt the maximum fault
current (including the short circuit current) allowed in the circuit.
Make sure that the Receiving Unit's power supply is protected against short
circuits and is supplied either by a battery or by a power supply unit with
safety isolating transformer. Limits provided in the technical data must be
observed (see chapter "Technical Data" in "Part D" of the Instruction Manual).
Never connect power supply positive or negative pole to the outputs. Such
connections damage the outputs and make ineective the UMFS and STOP
safety functions. In this case the Machine may be in a dangerous condition,
out of the User's control.