Manualshelf

User's Manual

ManualsBrandsAutec ManualsElectronicsTransceiver unit
21222324252627282930
26
LIUDJM000_eng-00
General operating instructions
AUTEC - Dynamic Plus series
8.12 Transmitting Unit automatic switch o󰓐
The Transmitting Unit automatically switches o󰘯 when:
- the battery is 󰘱at (see paragraph 8.12.1),
- the Radio Remote Control is not used for a certain time (see paragraph 8.12.2),
- the Transmitting Unit is powered and never switched o󰘯 for eight hours non-stop (see
paragraph 8.12.3).
The green LED on the Transmitting Unit blinks fast.
The POWER LED on the Receiving Unit illuminates steadily.
To start the Radio Remote Control, press the START pushbutton until the green LED repeats
one of the following sequences: one or two blinks and a pause. If the red LED lights up,
refer to chapter 11.
When the green LED repeats one of the following sequences: one or two blinks and a pause,
the Radio Remote Control is active and it can send commands and activate the Machine.
8.12.1 Low battery
The Transmitting Unit indicates if the battery is not su󰘲ciently charged (the red LED blinks
and an acoustic signal sounds).
The Transmitting Unit automatically switches o󰘯 after 3.5 minutes after the onset of the signal.
It is necessary to bring the Machine to a safe state and replace the battery with a charged
one (see paragraph 8.7).
8.12.2 When the Transmitting Unit is not used
If the Transmitting Unit remains started for a certain time while none of these commands are
enabled: SAFETY, D2-D10, H1-H8 and L1-L8, then it automatically switches o󰘯. This time
frame is speci󰘰ed in the Technical Data Sheet (Automatic Switch O󰘯).
Setting or removal of the automatic switch o󰘯 time (Automatic Switch O󰘯) is
done by Autec and decided by the Machine Manufacturer, according to his risk
assessment and to the e󰘲ciency and functions he need on the Machine.
8.12.3 Non-stop use
The Transmitting Unit indicates if it has been on for eight hours non-stop (the red LED blinks
and an acoustic signal sounds).
The Transmitting Unit automatically switches o󰘯 after 3.5 minutes after the onset of the signal.
Bring the Machine to a safe state before the Transmitting Unit automatically switches o󰘯.