User's Manual

Radio remote control lifecycle
Use
AUTEC - Dynamic Series
LIUDYN2AB0-01_eng.fm User manual
31
11.3 Use
The use of industrial radio remote controls is strictly limited to skilled and properly
trained personnel.
When the radio remote control is installed on mobile machines, switch off
the receiving unit when the vehicle travels.
All warnings for a correct use are given in chapter 10.
All instructions for a correct use are given in chapters 12 and 13.
Environmental working conditions are given in the following table.
11.4 Maintenance
The following instructions provide information to safely carry out routine and spe-
cial maintenance operations for the radio remote control.
They shall be completed by:
- instructions provided by the machine manufacturer
- directions provided by the installer of the radio remote control on the machine
- regulations regarding safety at work and accident prevention in force in the
country where the radio remote control is used.
All fine-tuning, checking and maintenance actions carried out on the radio remote
control shall be verified and recorded by the person in charge of carrying out
maintenance on the machine.
In case of failure, emergencies or damaged parts, disable the system “radio
remote control+machine” until the problem has been completely solved.
Never open the CRS receiving unit.
Before any maintenance operation:
- remove the battery from the transmitting unit
- disconnect power from the receiving unit.
Temperature Relative Humidity Air Pressure
Transmitting unit
Class 5K4H
-25°C to +55°C
[-13°F to +131°F]
Class 5K2
5% to 95%
Class 5K2
70 kPa to 106 kPa
Receiving
unit
Class 5K2
-25°C to +70°C
[-13°F to +158°F]