Instruction Manual

LIUCRP000_eng-00 AUTEC
26
Signals Possible reasons Solutions
The STATUS LED blinks slowly. Over-voltage on power supply.
Make sure that the Receiving
Unit power supply is within the
voltage limits provided in the
technical data.
The STATUS LED blinks fa󰘵 and
irregularly.
The Receiving Unit loses some
data sent by the Transmitting
Unit.
Bring the Transmitting Unit closer
to the Receiving Unit.
If this signal persi󰘵s, contact the
support service of the Machine
Manufacturer.
The RUN LED blinks.
The Receiving Unit does not
send commands in the CAN
network.
Contact the support service of
the Machine Manufacturer.
The ERR LED blinks. CAN communication error.
The Radio Remote Control has
been on for eight hours.
You need to switch off the
Transmitting Unit and 󰘵art the
Radio Remote Control again.
The SETUP LED blinks twice. Error on the memory card.
Contact the support service of
the Machine Manufacturer.