Instruction Manual

LIUCRP000_eng-00 AUTEC
18
7.1.2 "Take & Release" radio remote control
Signal Meaning
The Receiving Unit is taken by Transmitting Unit TU No.1, but the Units
do not communicate with each other.
The Receiving Unit is taken by Transmitting Unit TU No.2, but the Units
do not communicate with each other.
b
The radio remote control is 󰘵arted and the Receiving Unit is taken by
Transmitting Unit TU No.1.
c
The radio remote control is 󰘵arted and the Receiving Unit is taken by
Transmitting Unit TU No.2.
b c
Receiving Unit's internal temperature (°C).
b c
Receiving Unit's supply voltage (V).
b. These signals alternate when the radio remote control is 󰘵arted and the Receiving Unit is
engaged by Transmitting Unit TU No.1.
c. These signals alternate when the radio remote control is 󰘵arted and the Receiving Unit is
engaged by Transmitting Unit TU No.2.
7.2 POWER LED
The POWER LED indicates the 󰘵atus of the Receiving Unit and of the radio link.
Signals Meaning
The POWER LED is off. The Receiving Unit is off.
The POWER LED is on.
The Transmitting and Receiving Unit do not
communicate.
The POWER LED repeats the sequence: a blink
and a pause.
The Radio Remote Control is 󰘵arted and the Units
communicate via radio link in the 863-870MHz or
2400-2483.5MHz frequency band.
The POWER LED repeats the sequence: two
blinks and a pause.
The Radio Remote Control is 󰘵arted and the Units
communicate via radio link in the 915-928MHz
frequency band.
The POWER LED repeats the sequence: three
blinks and a pause.
The Radio Remote Control is 󰘵arted and the Units
communicate via cable control.