Instruction Manual
LIUDP1001_eng-00AUTEC
11
2 Brief product presentation
2.1 Series, Radio Remote Control and Unit
Autec Dynamic+P series' Radio Remote Controls are designed to be used on Machines and
provide a command interface to their command and control syem, to be used from an appropriate
diance and position.
2.2 Conformity with andards
This part of the Manual describes:
- the Dynamic+P series' Radio Remote Control compliance with the andards, the requirements
and conditions of use in each Country and
- the dierent frequency bands, in which the Radio Remote Control is able to operate.
2.3 Contacts and useful addresses
The Radio Remote Controls are produced by Autec Srl – Via Pomaroli, 65 - 36030 Caldogno
(VI) - Italy.
You can find contacts for Autec, its diributors, dealers and authorized service centres on the
website www.autecsafety.com.
2.4 Warranty
General warranty conditions are indicated both in the relevant sheet provided together with this
documentation, and in the specific page on the website www.autecsafety.com.
2.5 Technical assiance and spare parts
If you need technical services and/or spare parts, please refer to contacts provided in the website
www.autecsafety.com.
When applying for technical service to Autec, its diributors, dealers and authorized service
centres, the Radio Remote Control's serial number is required; you can find it on the identification
plate on the Transmitting Unit and/or on the Receiving Unit.