User's Manual
12
LIUDT1001_eng-00
Conformity
AUTEC - Dynamic Plus series
3 Conformity
Addressees of instructions must:
- make sure that the Radio Remote Control works within the frequency band permitted in
the country where it is used;
- make sure that the Radio Remote Control works correctly, in compliance with the applicable
standards in the relevant country;
- not modify the Radio Remote Control conformity, by performing modications or technical
operations that change its operation.
During training on or usage of Autec Radio Remote Controls, local provisions imposing the
conservation of product conformity with local standards must be respected, as well as specic
standards related to safety in the use of Radio Remote Controls or electrical devices, both
in the working environment or outside of it.
3.1 EC conformity
According to the regulations in force in the European Union, one of
the requirements for a Radio Remote Control to be compliant with
the EC conformity is to work at one of the permitted frequencies. If it
does not, the Radio Remote Control cannot be considered compliant.
Each Dynamic series' Radio Remote Control working in the 863-
870MHz frequency band complies with the (R&TTE) Directive 1999/5/
EC and its essential requirements.
Each Radio Remote Control also complies with the harmonised
standards listed in the EC Declaration of Conformity, that are in force
and applicable when the Radio Remote Control is put on the market.
Autec Radio Remote Control's EC Declaration of Conformity is
provided as an attachment with the Radio Remote Control.
3.2 FCC conformity
An ||nome_serie!! series' Radio Remote Control working in the 915-928MHz frequency band
complies with the requirements of the standards FCC (Federal Communication Commission)
Part 15.
The following table lists the approval identication codes for each type of Transmitting Unit
and for each type of Receiving Unit in the Dynamic Plus series.
Unit FCC ID
DJM Transmitting Unit
Model DJM Type NJ035
OQA-DJMNJ035
DJR Transmitting Unit
Model DJR Type NJ035
OQA-DJRNJ035
CRD Receiving Unit
Model CRD Type NK035
OQA-CRDNK035
a
a. Place the antenna of the Receiving Unit in a position that ensures a minimum separation distance
of 20cm with all the people that can be in the working area.