User's Manual

REMOTE SETUP procedure
AUTEC Dynamic Series
LIARSE00-01.fm Part D: ARS receiving unit
D - 9
ENG
6.3 Inversion of movement direction of the joystick's axis
1. Start up the radio remote control.
2. Press the TEACH pushbutton in the receiving unit and do not release it until
the SETUP LED illuminates.
3. Enable and release the “TEACH +” of the corresponding switch on the trans-
mitting unit and press and release the START pushbutton soon after.
4. Repeat actions described in point 3 until the SETUP LED on the receiving unit
starts blinking four times.
5. Set the desired values as follows:
- Move the joystick out of the rest position of the axis to be inverted. Maintain
this position and activate once the “TEACH +” command related to the cor-
responding switch on the transmitting unit.
- Press the STOP pushbutton to save the calibration. All calibrations are
saved in the data memory.
- To invert other directions, unlock the STOP pushbutton, press the START
pushbutton and repeat actions described in point 5.
6. To leave the procedure, press the TEACH pushbutton on the receiving unit
and do not release it until the SETUP LED switches off.
6.4 Restoring factory settings
1. Ensure that the transmitting unit is switched off.
2. Power on the receiving unit.
3. Press the TEACH pushbutton in the receiving unit and do not release it until
the SETUP LED illuminates.
4. Press the TEACH pushbutton on the receiving unit three times and do not re-
lease it at last pressure; the SETUP LED blinks fast: this indicates that factory
settings are being restored.
5. Release the TEACH pushbutton on the receiving unit when the SETUP LED
is steadily illuminated again.
If the TEACH pushbutton is released before the SETUP LED is steadily illumi-
nated, factory settings of proportional outputs will not be restored.
6. To leave the procedure, press the TEACH pushbutton on the receiving unit
and do not release it until the SETUP LED switches off.