User's Manual
6.2 Command activation
With the radio remote control started, act on the joysticks, pushbuttons and switches
corresponding to the command to be performed.
The user must be properly trained about the symbols on the transmitting unit panel, to be
aware of the matching between actuators and movements on the machine (symbols used are
dened by the machine manufacturer according to the functions of the machine).
6.3 Data Feedback Function
The user receives information and/or signals concerning the controlled machine by means
of the Data Feedback function.
During normal radio remote control operation, pay particular attention to the indications
displayed and signalled by the display or through the LEDs: they can be helpful to evaluate
the machine working status.
Any information shown and signalled on the display or through the LEDs
can never be considered or used as a safety signal or for legal metrology.
When operating and moving the machine, remember that the radio remote
control does not intervene autonomously when potential hazardous situations
are displayed and signalled.
6.3.1 Operation with display
If the transmitting unit has a display, it is possible to show signal icons, measurements
collected from the machine and their description.
Information displayed and how it is displayed (icons and/or measurements and/or descriptions)
depend on the settings chosen by the machine manufacturer.
The battery level and the quality of the radio link are also always indicated.
6.3.2 Operation with LED
If the transmitting unit has an LED array, specic machine conditions are signalled if they
are on (i.e. load limits, limit switch, …).
The signalled conditions depend on the settings chosen by the machine manufacturer.
8
LIAJRE00-00
General operating instructions
AUTEC - Air series