User's Manual

6 Values of proportional outputs
Proportional outputs in the ADD receiving unit are factory set: values are given in the technical
data sheet.
The REMOTE SETUP procedures is used to modify:
- maximum and minimum values of proportional outputs (see paragraph 6.1)
- rest position values related to the proportional outputs (o󰘯set) (see paragraph 6.2)
- movement direction of the joystick's axis (see paragraph 6.3)
The REMOTE SETUP procedure can only be performed by skilled and
properly trained personnel.
During the REMOTE SETUP procedure, pay particular attention to the machine
behaviour, as it moves as a response to acting on the actuators.
If necessary, it is possible to restore factory settings at any time (see paragraph 6.4).
6.1 Calibrating maximum and minimum values of proportional outputs
1. Start up the radio remote control.
2. Press the TEACH pushbutton in the receiving unit and do not release it until the SETUP
LED illuminates.
3. Set the desired values as follows:
- To set the maximum value, move the joystick to the maximum range of the semi-axis
to be calibrated. Maintain the position and use the TEACH selector on the transmitting
unit to set the desired value.
- To set the minimum value, move the joystick slightly out of the rest position of the
semi-axis to be calibrated. Maintain the position and use the TEACH selector on the
transmitting unit to set the desired value.
- After calibrating one joystick, press the STOP pushbutton to save calibrations.
Calibrations are saved in the data memory on the DTK connector.
4. To set other values, unlock the STOP pushbutton, press the START pushbutton and
repeat actions described in the previous point.
5. To leave the procedure, press the TEACH pushbutton on the receiving unit and do not
release it until the SETUP LED switches o󰘯.
AUTEC - Dynamic Series
Values of proportional outputs 9
LIADDE00-00