User's Manual

5.5 ERR LED (red)
The ERR LED indicates the status of the CAN communication.
The ERR LED... Meaning
…is o󰓐 The CAN communication is working correctly.
… blinks The CAN communication does not work correctly.
...is on No CAN communication.
ERR LED signals re󰘱ect the guidelines of the CANopen® standard, CiA recommendation 303-3.
5.6 SETUP LED (yellow)
The SETUP LED shows the status of the data memory and of the address key, depending
on the receiving unit's working status.
The SETUP LED... Meaning
...is o󰓐 The receiving unit works correctly.
... blinks once Error on the address key.
... blinks twice Error on the memory board.
...blinks slowly three times
Calibration of values related to the rest position of
proportional outputs (see paragraph 6.2) or the procedure
“Copy of the memory board” (see chapter 7) are being
performed.
...blinks quickly three times
The receiving unit is saving data set with the REMOTE
SETUP procedure (see chapter 6).
... blinks four times
Inversion of movement direction of the joystick's axis is
being performed (see paragraph )
... blinks slowly A memory board is connected to the BKK connector.
... blinks fast
This signal has two meanings, depending on the current
working status:
- the receiving unit is restoring factory settings (see
paragraph 6.4)
- the memory board is being copied (see chapter 7).
...is on
Calibration of maximum and minimum values of
proportional outputs is being performed within the
REMOTE SETUP procedure (see paragraph 6.1).
AUTEC - Dynamic Series
Plates 7
LIADDE00-00