User's Manual
7 Memory board backup
The receiving unit has two memory boards: one is in the DTK connector on the mother board
and one is attached inside the cover (backup memory board).
When data of proportional outputs are modió°˜°ed, they are saved in the memory board present
in the DTK connector.
N
P
N DTK connector
P BKK connector
The memory board in the DTK connector can be copied into a backup memory
board. This is useful in case you need to restore the information contained.
In this case, use the memory board attached inside the cover.
Please note that information contained in the memory board in the DTK
connector overwrites the memory board of the BKK connector during the
backup procedure.
If one of the memory boards is lost or damaged, ask the machine manufacturer
for a new one.
Perform the following steps to copy the information of the memory board.
1. Make sure that the transmitting unit and the receiving unit are not powered.
2. Open the receiving unit.
3. Make sure that a memory board is plugged into the DTK connector.
4. Insert the memory board attached inside the receiving unit cover in the BKK connector.
5. Power on the receiving unit: the SETUP LED blinks slowly.
6. Press the TEACH pushbutton on the receiving unit: the SETUP LED blinks fast (indicating
that data are being copied); release the button when the LED starts blinking slowly again.
7. If the TEACH pushbutton is released before the SETUP LED starts blinking slowly again,
data contained in the memory board will not be copied.
8. Remove power from the receiving unit.
9. Remove the memory board plugged in the BKK connector and attach it inside the cover.
10. Close the receiving unit.
12
LIADDE00-00
Memory board backup
AUTEC - Dynamic Series