User's Manual

1 Conformity
Each Dynamic series' radio remote control working in the frequency band 915-928MHz
complies with Part 15 of standards FCC and with RSS-210 of IC standards.
Unit FCC ID IC number
ADD OQA-ADDNE022 9061A-ADDNE022
a b c
ARM
OQA-ARMNB022
OQA-ARMNC022
9061A-ARMNB022
a b c
9061A-ARMNC022
a b c
ARS OQA-ARSND022 9061A-ARSND022
a b c
CRS OQA-CRSNA022 9061A-CRSNA022
a b c
FJL OQA-FJLNF022 9061A-FJLNF022
FJM OQA-FJMNF022 9061A-FJMNF022
FJR OQA-FJRNF022 9061A-FJRNF022
FJS OQA-FJSNF022 9061A-FJSNF022
a. Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
b. This radio transmitter has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each antenna
type indicated. Antenna types not included in this list, having a gain greater than the maximum
gain indicated for that type, are strictly prohibited for use with this device.
Antenna type Antenna gain Antenna impedance
Autec stylus λ/4 <2dBi 50 Ohm
Autec stylus λ/4 with 5m
RG58
<2dBi 50 Ohm
Autec stylus λ/4 with 20m
RG213/U
<2dBi 50 Ohm
c. Autec allows you to use only the dedicated antenna supplied either with the remote control or
as original spare part. The use of any other type of antenna is prohibited and will invalidate the
guarantee.
2
LIDY2I00-04
Conformity
AUTEC - Dynamic Series