User's Manual

Risk assessment 27
Frequency band 915-928 MHz
LIUAIR1AE0-02.fm
AUTEC - AIR series
2.2 Frequency band 915-928 MHz
2.2.1 Conformity
Each AIR series' radio remote control working in the frequency band 915-928 MHz complies
with the essential requirements of the following regulations:
- FCC (Federal Communication Commission) Part 15
- IC (Industry Canada) RSS-102
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
2.2.2 Frequencies
The radio link between the units of Autec AIR series radio remote controls is built at one of
the frequencies permitted by the US and Canadian standards in force when the system is put
on the market.
Frequencies used in the frequency band 915-928 MHz ................................................. 256
RF power............................................................... complies with FCC and IC requirements
Channel spacing ........................................................................................................ 50 kHz
2.2.3 Market
Air series' radio remote controls working in the frequency band 915-928 MHz can be used in
the US and Canadian markets.
3 Risk assessment
Always evaluate whether the machine can be radio remote controlled. In fact, as required by
technical standards specific to the market where the system “machine+radio remote control”
is used, each machine must undergo risk assessment and risk analysis.
The radio remote control can only be installed if this assessment gives positive results.
The machine manufacturer and/or the person who decides upon radio remote
control installation and use is responsible for this risk assessment.
Autec cannot be held responsible if this assessment has not been carried out correct-
ly or is incomplete.
Unit FCC ID IC number
A8 OQA-A08LA0AM 9061A-A08LA0AM
Receiving unit G OQA-RGAAA00M 9061A-RGAAA00M