User's Manual

AUTEC - AIR series

34 A8 transmitting unit

Battery AIRBM3V7L

4.4 Battery AIRBM3V7L

The A8 unit contains a rechargeable battery; the provided battery is partially charged.

The document “Battery AIRBM3V7L” shall be understood and kept into account to

correctly use the A8 unit and its battery; you can find this document in the dedicated

section on Autec website.

Do not throw the batteries away with domestic trash. Apply local rules when

disposing of them: different collection and recycling schemes for batteries in

compliance with are the 2006/66/EC Directive and amendments.

4.4.1 Recharging the A8 unit

First power on the docking station with its power supply unit and then:

1) insert the A8 unit into the docking station: a steady on red

LED indicates that charging has started (max. 4 h)

2) remove the A8 unit from the docking station when necessary

Note: when the green LED switches on, the A8 unit is complete-

ly charged.

Charge the unit at a temperature between 5°C and 45°C.

4.4.2 Indication of A8 unit run time

Perform the following procedure to check the transmitting unit's run time:

1) switch off the transmitting unit and unlock the STOP pushbutton

2) keep pushbuttons S1 and START pressed until the 3 left LEDs illuminate

showing the unit's run time (3 illuminated LEDs correspond to the highest

run time).

Run time indication disappears after some seconds.

4.5 Docking station AIRDOCK01

The docking station AIRDOCK01 is used to recharge the A8 unit.

Plug in the adapter in the socket on the back of the docking station.

The adapter works with 100 - 240 V~ (optional 10 - 30 V ).

Respect instructions provided in the document “Docking sta-

tion AIRDOCK01” to correctly use the docking station itself;

you find this document in the dedicated section on Autec web-

site.

STARTFUNCT.

STOP

S1 S2

START

MAX. MIN.