Specifications

PAGE 5XRS SERIES INSTALLATION AND OPERATION MANUAL
REAR PANEL POWERED VERSION
15
13 14
10
11
12
7
8
9
2
4
6
5
3
1
1
MIC IN
This is a balanced XLR microphone input.
2
Mic SIGNAL
This is a green LED signal present
indicator for the Mic input.
It indicates
signal present on the input and is not
affected by the level control.
3
LINE IN
This is a balanced XLR line level input.
4
Line SIGNAL
This is a green LED signal present
indicator for the Line input.
It indicates
signal present on the input and is not
affected by the level control.
5
LINE OUT
The LINE OUT is on an XLR connector
.
This output can be connected to the LINE
IN on another XRS Powered speaker to
expand the system.
6
Output CLIP
This is a red LED clip indicator for the
mixed mic and line audio signal.
Some
fl ashing of red is acceptable on program
transients. Continuous fl ashing of red
could be placing undue stress on the
speaker and will sound distorted. Turn
down the input level until the clip LED is
no longer lit.
7
Mic LEVEL
This controls the level of the MIC input
(1).
8
Mic BASS
This is the bass control for the MIC input
(1).
There is 12dB of cut and boost at
100Hz. This EQ is the shelving type.
9
Mic TREBLE
This is the treble control for the MIC input
(1). There is 10dB of cut and boost at
10kHz. This EQ is the shelving type.
10
Line LEVEL
This controls the level of the LINE input.
(3)
11
Line BASS
This is the bass control for the LINE input
(3).
There is 12dB of cut and boost at
100Hz. This EQ is the shelving type.
12
Line TREBLE
This is the treble control for the LINE
input (3).
There is 10dB of cut and boost
at 10kHz. This EQ is the shelving type.
13
Power Switch
This switch turns the power on or off to
the unit.
14
IEC Mains Input Socket
This is a standard IEC 3 pin socket.
It accepts a standard IEC mains cable,
(provided). The fuse draw contains the
mains fuse and a spare.
The mains fuse is a time lag (slow blow)
HRC 20mm x 5mm ceramic or glass type
fuse.
XRS8P XRS10P XRS12P
2.5A 2.5A 5.0A
IMPORTANT: Always replace the
fuse with one of the same value and type.
NOTE: Always disconnect power to
the amplifi er before replacing fuses.
15
Voltage Select Switch
This switch is used to select the mains
voltage for your region.
Select either
230V or 115V.
IMPORTANT: Disconnect power to
the amplifi er before operating this switch.
IMPORTANT: Make sure this setting
is correct before connecting the unit to
the mains.