Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
44-902-34
(a)
(b)
Figure 3-3. Torque Wrench Set
Disconnect cable assembly W 1 conector
W1P1 from CDU (4) connector 4J1.
Release clamping catches securing CDU (4)
to computer (5) if CDU is being stored on
top of computer. If CDU is mounted on
utility truck dashboard, release clamping
catches securing CDU to CDU bracket.
(2) Replacement.
(a) Secure CDU (4) to top of computer (5) or to
CDU bracket on utility truck dashboard.
(b) Connect cable assembly W 1 connector
W1P1 to CDU (4) connector 3J1.
b. Computer. Remove and replace computer (5,
figure 3-6 with computer power supply (6) as follows:
(1) Removal.
(a) See figure 3-1 and disconnect cables from
computer as follows:
1. Disconnect cable assembly W 1 connector
W1P1 from computer connector 1J3.
2. Disconnect cable assembly W2 connector
W2P2 from computer connector lJ1.
3. Disconnect cable assembly W3 connector
W3P2 from computer connector 1J4.
NOTE
If CDU (4) is being stored on top of
computer, remove as described in previ-
ous paragraph.
(b) Loosen four captive screws (3) securing
computer power supply (6) to computer
mounting base (12). Remove computer (5)
with computer power supply (6).
(2) Replacement.
(a) Place computer (5) with computer power
supply (6) on computer mounting base (12).
Align mounting holes.
(b) Tighten four captive screws (3) securing
computer power supply (6) to computer
mounting base (12).
(c) See figure 3-1 and connect cables to com-
puter as follows:
1. Connect cable assembly W 1 connector
W 1P2 to computer connector 1J3.
2. Connect cable assembly W2 connector
W2P2 to computer connector lJ1.
3. Connect cable assembly W3 connector
W3P2 to computer connector 1J4.
3-21