Install guide

12.
Press -
to scan ID’s 50, 49, 48, and 47 to verify the
entered values are correct. Above operator action must be
repeated if a change is to be made.
(2) In the event more than one nonstandard vehicle is
to be entered into memory, repeat above operator action
making sure that when performing third step, a number
other than the one previously entered is used, i.e., 9, or 10.
If the number 8 were entered again, X, Y, Z, and V dimen-
ions previously entered would be cleared from memory. A
save routine at shutdown will store all nonstandard vehicle
selections which have been entered.
(3) In the event a vehicle selection change is necessary
during a mission, the new vehicle lever arms may be sel-
ected by returning to the monitor table and proceeding as
follows:
ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
f. A display showing “E” 0:
.0, means PADS
wants the universal transverse mercator (UTM ) zone
and casting coordinate entered. Zone is entered first and
will eventually appear to the left of the colon. The
coordinate must have 7 digits and be entered to the
nearest tenth of a meter.
Example Enter an casting value of 246789.7 for zone
Check that data is correct before entering.
Press ENT.
“N”
.0
The cues for the other parameters are:
“N” .0 UTM northing - entered to near-
est tenth of a meter. For southern
hemisphere, press N twice. Dis-
play will change from N to S.
“EL” .0 Elevation –
entered to nearest
tenth of a meter. When EL is
pressed PADS will display ±EL.
For an elevation above mean sea
level press ±2.
For an e
levation
below mean sea level, press -8.
Then enter the numerical value.
g. Data maybe displayed by pressing the key corre-
sponding to the parameter desired. However. the opera-
tor cannot select a data display until the initial survey
data has been entered.
Change 5
3-6.1