Install guide

ARMY TM 5-6675-308-34

MARINE CORPS TM 08837A-34/2

3. SUV 3

Susv

Left

side driver

sight/plumb bob

4. M151 4

Jeep

Pintle mounted

plumb bob

5. OH-58 5

OH-58

PADS mounted

Helicopter plumb bob arm

6. UH-1 6

UH-1

PADS mounted

Helicopter plumb bob arm

7. PLMB 7 M151 Jeep PADS mounted

plumb bob arm

e.2 The operator presses CDU ±/2 or -/8 to ad-

vance or decrement the vehicle selection until the correct

vehicle has been displayed then presses ENT. The

vehicle selection may be changed at any time during

operation which allows vehicle to vehicle transfer while

the system is operational.

e3.

the

system has been installed in a vehicle which

is not defined as one of the seven standard vehicles, or

has not had the lever arms previously entered the

operator must enter any choice of vehicles in order to

proceed with the initialization. The procedure for

selecting and inserting data for the nondefined vehicle is

as follows:

(1) While PADS is aligning or preferably after align-

ment is complete, the operator may insert up to three

nonstandard vehicle selections after determining the X,

Y, Z, and V lever arm dimensions using figure 3-1.1 as

an example. All lever arm entries and displays must be

in meters to the nearest millimeter.

Change 6

3-5