Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 3-1. Direct Support Test Procedure - Continued
Step
CDU Data Status
no. Operator action
display indicators
Reference
8.
9.
10.
11.
12.
13.
14.
15.
Enter spheroid; PADS cues for
easting
Enter zone and casting PADS
cues for northing
Enter northing PADS cues for
elevation
Enter elevation; alignment
continues
Alignment ends
Press ON/OFF
Press ENT. PADS shuts down
Disconnect equipment
“E”
.0
Para 3-5
“N”
.0
Para 3-5
“EL”
.0
Para 3-5
MODE O
ENT CAL MON
Para 3-5
MODE 1
Note 2
MODE 2
Z-VEL
Para 3-6
MODE 3
MODE 4
MODE 5
MODE 6
MODE 7
MODE 8
OFF C-E
or
SAVE GE
Note 4
TEST COMPLETE
Note 1.
Note 2.
Note 3.
Note 4.
BATT may light for a few minutes. If it stays lighted verify connections to + 28V power and battery box
and that BATTERY and VEHICLE circuit breakers CBl and CB2 are ON. CHRC may light throughout
the mission.
The display may initially show MODE 0, 1, 2, or 3 depending on the speed of coordinate entry. Time since
turnon may be displayed by pressing TIME. The mode may be recalled by pressing MON.
MON will extinguish when any other function k selected. No display functions can be selected by the
operator until the survey data has been entered
If ON/OFF is pressed and CDU d lay indicates
SAVE C-E the computer contains a solid state memory
instead of a core memory and tbe following turn off steps must be performed:
a. Press ON/OFF. Display indicates SAVE C-E
b. Press ENT. Display indicates PAUSE.
c. In approximately 20 seconds the display will indicate “OFF” E.
d. Press ON/OFF. Display indicates OFF “E”.
e. Press ENT. System will turn Off.
3-4 Change 5