Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 3-1. Direct Support Test Procedure
Step
CDU Data
Status
no. Operator action
display
indicators
Reference
NOTE
sequences.
More detailed descriptions are in the paragraphs listed in the
This table summarizes PADS operational
Reference column.
a. CDU pushbuttons are
underlined e.g., press STOP.
A lighted status indicator is
shown in Status Indicators
column and remains lighted
until extinguished.
An extinguished status
indicator is boxed in.
Flashing displays are
enclosed in quotation marks.
GO
b.
e.g.
“GO”
e.
e.g.
e.g.
.d
These conventions are used
throughout this manual.
1.
Set up equipment as shown in
figure 3-1
Para 3-2
Para 3-3
2.
Turn on +21V power source
and set BATTERY and
VEHICLE circuit breakers
CB1 and CB2 to ON
Note 1
Para 3-4
3.
Press ON/OFF
“SPH” 1 or
“GPS C-E”
STOP, ENT
(All lamps light.)
4. Perform lamp test
(All lamps light.)
NOTE
All fault indicators set
white when LAMP
is pressed and reset black
when LAMP is released.
STOP, ENT
Para 3-4
Para
3-5
5. Set lamp intensity
“SPH” 1 or
“GPS C-E”
5.1 Enter CLR (for solid state
“ss
SPH”
memory only)
6.
Enter spheroid
“PAUSE” (for solid
state memory only)
7. When “PAUSE” extinguishes,
“HUM” 1
Para 3-5
PADS cues for a vehicle entry.
The cue will be the last vehicle
that had been used. Press ENT
Change 6 3-3