Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 4-18.1. Operational Program Loading Using Tape Reader, Part No. 877406-2 — Continued
Malfunction
Test procedure
Normal indication indication/corrective action
ae. Press MEMORY LOAD switch-
indicator to off
af. Deleted
ag. Press REVERSE switch-indica-
tor to on
ah. Press REVERSE switch-indica-
tor to off
ai. Deleted
aj. Press VERIFY switch-indicator
to on
ak. Press VERIFY switch-indicator
to off
al. Deleted
am. Press REVERSE switch-indica-
an.
ao.
ap.
aq.
ar.
tor to on
Press REVERSE switch-indica-
tor to off
Lift tape reader read head cover
and remove IMU alignment tape
from tape reader and store in
IMU compartment
Press EXECUTE switch-indica-
tor to on
Wait 15 seconds and press EXE-
CUTE switch-indicator to off
Sequentially press ON/OFF
switch-indicator and ENTER
switch
as. Set PS BATTERY and VEHI-
CLE circuit breakers CB1 and
CB2 to OFF
at. Press SPU ON switch-indicator
to off
au. Disconnect W204 from com-
puter and connect CDU cable
W1 to computer
MEMORY LOAD switch-indicator
goes off
REVERSE switch-indicator lights
Tape rewinds and stops at beginning
REVERSE switch-indicator goes off
VERIFY switch-indicator lights
VERIFY ERROR switch-indicator
Tape reader reads tape and stops at
lights and tape stops: Refer to step
end
2h of table 4-6.1
REVERSE switch-indicator lights
Tape rewinds and stops near begin-
ning
REVERSE switch-indicator goes off
System turns off
SPU ON switch-indicator goes off
Change 6
4-106.5