Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 4-18. Operational Program Loading – Continued
Malfunction
Test procedure
Normal indication
indication/corrective action
ae. Press REVERSE switch-indica-
tor to on
af. Press REVERSE switch-indicator
to off
ag. Press VERIFY switch-indicator
to on
ah. Press VERIFY switch-indicator
to off
ai. Press REVERSE switch-indicator
to on
aj. Press REVERSE switch-indicator
to off
ak. Set tape reader SPOOLING
switch to DISABLE
al. Remove IMU alignment tape
from tape reader and store in
IMU compartment
am. Press EXECUTE switch-indica-
tor to on
am.1. Wait 15 seconds and press
EXECUTE switch-indicator
to off
an. Sequentially press
ON/OFF
switch-indicator and ENTER
switch
ao. Set BATTERY and VEHICLE
circuit breakers CB1 and CB2 to
OFF
ap. Press SPU ON switch-indicator
aq.
ar.
to off
Disconnect W204 from com-
puter and connect CDU cable
W1 to computer
Turn on PADS via CDU and ad-
vance to monitor mode
NOTE
Zeros may be entered for values of
survey parameters
REVERSE switch-indicator lights
Tape rewinds and stops at beginning
REVERSE switch-indicator goes off
VERIFY switch-indicator lights
VERIFY ERROR switch-indicator
Tape reader reads tape and stops at
lights and tape stops: Refer to step
2h of table 4-6
end
REVERSE switch-indicator lights
Tape rewinds and stops near begin-
ning
REVERSE switch-indicator goes off
System turns off
SPU ON switch-indicator goes off
Change 1 4-105