Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 4-18. Operational Program Loading — Continued
Malfunction
Test procedure
Normal indication
indication/corrective action
t. Wait 15 seconds and press EXE-
EXECUTE switch-indicator goes off
CUTE switch-indicator to off
u. Press MEMORY LOAD switch-
MEMORY LOAD switch-indicator
indicator to on
lights
Tape reader reads rest of tape and
stops at end of reel
v. Press MEMORY LOAD switch- MEMORY LOAD switch-indicator
indicator to off
goes off
w. Press REVERSE switch-indicator REVERSE switch-indicator lights
to on
Tape rewinds and stops near begin-
ning
x. Press REVERSE switch-indicator REVERSE switch-indicator goes off
to off
NOTE
Repeat steps w and x to completely
rewind tape.
y. Set tape reader SPOOLING
switch to DISABLE
z. Remove tape from reader
NOTE
Normally, the IMU calibration data
already is in memory because an
IMU alignment was performed. If
this is the case, proceed to step a1.
If an IMU alignment tape is to be
loaded, continue with step aa.
It is easier to handle the alignment
tape if it is installed on a reel.
aa. Install IMU alignment tape on
tape reader
ab. Set tape reader SPOOLING
switch to ENABLE
ac. Press MEMORY LOAD switch- MEMORY LOAD switch-indicator
indicator to on
lights
Tape reader reads tape and stops
near end
ad. Press MEMORY LOAD switch- MEMORY LOAD switch-indicator
indicator to off
goes off
4-104 Change 5