Install guide

ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
Table 4-6.2. Solid State Memory Loading- Continued
Malfunction
Test procedure Normal indication indication/corrective action
lj. Press
EXECUTE switch-
indicator to off to halt computer
2. SOLID STATE PROGRAM
LOAD
2a. Press MEMORY LOAD switch-
indicator to on to load program
NOTE
Press MEMORY LOAD switch-
indicator off and back on if a stop
code is reached prior to taped data
being read.
2b. PressMEMORYLOAD switch–
indicator to off
2c. Press REVERSE switch-
inicator to on
2d. Press REVERSE switch-
indicator to off
NOTE
Tape will stop near the beginning of
the reel. Repeat steps 2c and 2d until
tape stops at end of readable leader.
2e. Set tape reader SPOOLING
switch to DISABLE
2f. Remove part 1 and load part 2
(of 3) of PADS solid state pro-
gram 868182-X on tape reader
2g. Set tape reader SPOOLING
switch to ENABLE
2h. Press MEMORY LOAD switch-
indicator to on
NOTE
Memory clear routing will begin automat-
ically. When completed, TTY will print
out LOAD NEXT TAPE SECTION
EXECUTE switch-indicator goes off
MEMORY LOAD switch-indicator
lights. Tape reader reads tape and stops
after first reel has been read
NOTE
Ignore
PARITY ERROR switch-
indicator light unless tape stops.
MEMORY LOAD switch-indicator goes
off
REVERSE switch-indicator lights. Tape
rewinds and stops at beginning of reel
REVERSE switch-indicator goes off
MEMORY LOAD switch-indicator
lights. Tape reader reads tape and stops
at end of reel
I/O discrete circuit card assembly A9
Control no. 2 circuit card assembly A4
Control no. 1 circuit card assembly A3
16-bit data circuit card assembly A2
TTY prints out:
MEMORY TEST FAIL
Replace cards in sequence given:
Memory unit Al
16-bit data circuit card assembly A2
Control no. 2 circuit card assembly A4
Control no. 3 circuit card assembly A5
Control no. 1 circuit card assembly A3
EXECUTE switch-indicator remains
on:
Same card replacement as step 1i
Tape stops before end of tape. Replace
tape or rerun clear memory routine
and attempt to load again
4-54.12
Change 6