Install guide
ARMY TM 5-6675-308-34
MARINE CORPS TM 08837A-34/2
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Figure 3-16. Utility Truck Winterization
centerline of the six screw holes (four 5/18-
inch diameter holes and two 1/4-inch diame-
ter holes) are aligned within 0.900 to 0.960
inch from outboard edge of rear panel. Locate
top edge of side mounting plate 1/16 inch
below top edge of rear panel.
Using side mounting plate as a template, cen-
ter punch the screw hole locations in rear
panel, Remove side mounting plate.
Drill the screw holes through rear panel to the
diameters shown in figure 3-16, sheet 2. Use
l/4-inch and 5/M-inch drills, as applicable.
Place mounting plate 880528-1 (14) on inner
surface of rear panel and side mounting plate
880524-1 (7) on outer surface of rear panel.
Align the screw holes in the plates with the
screw holes in rear panel.
Install the four 1/4-28 X 3/4-inch screws (9),
washers (8) and locknuts (10) and tighten.
Place handle (6) in position on side mounting
plate and secure with two 10-32 X 3/4-inch
screws (13), lockwashers (12), and washers
(11).
Repeat steps (1) through (7) for left side using
880524-2 side mounting plate.
Kit Installation Diagram (Sheet 9 of 9)
d. Install Bottom Plate 88052S (6, figure 3-16,
sheet 3) on Rear Panel.
(1)
(2)
(3)
(4)
(5)
(6)
Locate centerline of rear panel near its bot-
tom edge and mark location.
Place top of plate (6) parallel to bottom edge
of rear panel.
Center the bottom plate about the centerline
of the rear panel and locate centerline of the
top screw holes 0.340 to 0.400 inch from rear
panel bottom edge.
Using bottom plate (6) as a template, center
punch the four top screw holes. Remove bot-
tom plate.
Drill four 5/16-inch screw holes through rear
panel.
Install four 1/4-28 X 3/4-inch screws (8), flat
washers (4), and locknuts (3) and secure bot-
tom plate to rear panel.
e. Install Angle Bracket 880523 (4, figure 3-16,
sheet 4).
(1) Place angle bracket (4) at top of rear panel.
Align top of 3/4-inch lip even with top edge
of rear panel and edges of 1 1/4-inch lip
equidistant between inner edges of left and
3-56