Specifications

PAGE 4 AMIS MP8 INSTALLATION AND OPERATION MANUAL

Monitor Speaker

A 2.5” speaker is located behind a cloth grille. No cleaning is required.

Monitor Speaker

Volume Control

This knob controls the volume level of the monitor speaker.

NOTE: The Speaker Volume Control does not affect the level of the

VU indicator nor does it affect the ampliﬁers or speaker lines that are

connected to the MP8.

VU Meter

This meter indicates the output level of the currently selected ampliﬁer. The 0dB

level is referenced to 100V. This is an RMS meter, not a peak meter.

Selector Switches

These switches select which ampliﬁer is connected to the monitor and meter

circuits. The switches are mechanical interlocking push buttons, meaning that

when one button is pushed, the previously selected switch is mechanically

deselected.

Select Indicator

This LED indicator will illuminate to show which ampliﬁer is selected for

monitoring.

Signal Present

This LED will light dimly when the signal from the corresponding ampliﬁer

reaches approximately -24dB (6.3Vac) indicating signal is present and will get

progressively brighter with increased signal level.

NOTE: Signal present indication is irrespective of which ampliﬁer is

selected. This indicator is a passive circuit across the ampliﬁer input and

will indicate signal across each speaker line even when the MP8 is not

powered.

Labels

This area is available to custom label the zones each ampliﬁer is driving.

Power Switch

This switch switches power from the AC/DC plug pack input.

NOTE: When using 24VDC IN terminals the unit is on regardless of

switch position.

Power On LED

This indicates there is power to the unit.

NOTE: When using 24VDC IN terminals the power LED will always

be on.

1 2 3 4 7 8 95 6

FRONT PANEL