Specifications

When wiring for an unbalanced source:
Pin 1 =GROUND/SHIELD,
Pin 2 = HOT (in phase with the amplifier’s output),
Pin 3 = GROUND/SHIELD (joins to pin 1).
In-line XLR connectors often have a termination lug that connects directly to the chassis of the connector.
Do link this lug to pin 1 at the amplifier’s input as it will defeat the amplifier’s input grounding scheme.
When wiring to your speakers always use the largest gauge wire your connector will accept. The longer the
speaker lead, the greater the losses will be, resulting in reduced power and less damping at the load. We
recommend using a heavy duty, two core flex (four core flex if bi-amping) 10 to 12 gauge (2mm to 2.5mm or
50/0.25 or equivalent) as a minimum.
When terminating to the 4 mm binding post (banana jack) output connectors, banana plugs or bare wires can be
used. The red terminal is and the black terminal is (ground).
If running in BRIDGE mode, only the binding posts are used.
NOTE:
not
positive negative
red
Output Wiring
,
,
22
8 Installation
AV2.2P