Specifications

PAGE 7AMC
+
MIX SERIES INSTALLATION AND OPERATION MANUAL
TROUBLESHOOTING AND BLOCK DIAGRAM
Troubleshooting Guide
Trouble Likely Cause Remedy
Power LED not on Check power switch is on Check plug pack connection
Distorted sound Input is overloaded
Output is being over driven
Bass control is turned up
Reduce input level at source
Reduce volume levels on front panel
Reduce Bass control level
No sound but mixer is on Volume controls down
Connected amplifier is switched off
Check volume controls
Check amplifiers and speakers
No sound from channels 2 and 3 Priority function is being used
Remove signal (disconnect input) from channel 1 OR
Disable priority function (see Internal Adjustments)
Tones do not sound when triggered Tone generator module not installed Purchase optional Tone generator module