ACM120P 120w Power Amplifier SIGNAL ON POWER Operating Manual
ACM120P, 120 Watt Power Amplifier Product Description The ACM120P is a 120 watt single channel power amplifier designed for commercial installations. It can be used for either low impedance (4 or 8 ohm) or 70v/100v line speaker systems. The amplifier can be mounted in a standard 19” equipment rack (rack ears supplied) or it can be used on a shelf or table. The ACM120P features a line level input (with parallel output) and is normally used with mixers, mixer amplifiers or other power amplifiers.
INPUT AM P 1 LEVEL 1 XLR 1 = Ground 2 = + Signal 3 = - Signal ENGIN EERED BY AUDIO TELEX C OMM UN IC ATI ON S PTY LTD SYDN EY AUS TRALIA Rear Panel Features AC Power Inlet The 3 pin IEC power inlet is located on the bottom left of the rear panel and accepts a standard mains power lead fitted with an IEC connector. Before plugging in a power lead, please check the rear panel of the amplifier to ensure that the voltage label shows the correct AC operating voltage for your part of the world.
Fuse Sizes Mains, 240VAC: 4 Amperes Slow Blow. Notes: The DC fuse is located on the circuit board. This is a feature of the ACM series amplifier, which is equipped with a current limitting circuit preventing excessive DC current, thus eliminating the risk of blowing high tensions fuses. In the unlikely event that the DC fuse actuates, the output transistors should be checked, as it is probable that the amplifier has been subjected to very extreme conditions.
Important Safety Information 1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. 2. Read all documentation before operating your equipment. Retain all documentation for future reference. 3. Follow all instructions printed on unit chassis for proper operation. 4. Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. 5.
Engineered by Audio Telex Communications Pty Ltd, Sydney, Australia A.B.N. 78 001 345 482 Inc in NSW www.audiotelex.com.au Export Sales & Corporate Head Office Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Australia Ph: 61-2- 9647 1411 Fax: 61-2-9748 2537 E-mail: ho@audiotelex.com.au Sydney (NSW & ACT Sales) Private Bag 149, Silverwater NSW 1811 149 Beaconsfield Street, Silverwater NSW 2128 Ph: (02) 9647 1411 Fax: (02) 9648 3698 E-mail: nsw@audiotelex.com.
