User manual

www.austin-hughes.comUM-IGM-03-Q413V3
P.31
Write down the new IP address & password
for < Setup > purpose, refer to P.40
Please take the following steps to con gure the Master EC box.
Step 1. Prepare a notebook computer to download the IP setup utilities from the link :
http://www.austin-hughes.com/support/utilities/infraguard/MasterIPsetup.msi
Step 2. Double Click the MasterIPsetup.msi and follow the instruction to complete the installation
Step 3. Go to each Master EC box with the notebook computer & a piece of CAT. 5 / 6 cable to set up the IP con guration
by IP setup utilities as below. Please take the procedures for all Master EC box ONE BY ONE
Master EC box
EC-300M
To notebook computer
LAN port
To LAN port
CAT. 5 / 6 cable
Step 4. Click Scan ” to search the Master EC box
Step 5. Enter device name in “ Name “ ( min. 4 char. / max. 16 char. ). Default is “ Name
Step 6. Enter device location in “ Location “ ( min. 4 char. / max. 16 char. ). Default is “ Rack_001
Step 7. Enter password in “ Password “ for authentication ( min. 8 char. / max. 16 char. ). Default is “ 00000000
Step 8. Enter new password in “ New password “ ( min. 8 char. / max. 16 char. ).
Step 9. Re-enter new password in “ Con rm new password
Step 10. Change the desired “ IP address “ / “ Subnet mask “ / “ Gateway “, then Click “ Save “ to con rm the changes
The default IP setting is as below:
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Gateway: 192.168.0.254
Reconnect the Master EC box with the network device
( router or hub ), after nish master IP con guration.
Ensure the Master EC box in
power ON status
< 4.2 > Master IP Con guration