Austin Hughes Electronics NCP-1716 : User manual : Page 22

2.4 Changing Operating Parameters Chapter 2

Baud Rate Preset with “9600”, changing the parameter will cause the local acess console

malfunction

Rcv Hndahake Preset with “None”, changing the parameter will cause the local acess console

malfunction

Data / Stop Bits Preset with “8/1”, changing the parameter will cause the local acess console

malfunction

Xmt Hndshake Preset with “None”, changing the parameter will cause the local acess console

malfunction

Parity Preset with “None”, changing the parameter will cause the local acess console

malfunction

Comm Mode Preset with “FDX”, changing the parameter will cause the local acess console

malfunction

Printer This setting is not support in this model

Selection

Ethernet Mode This setting is not support in this model

Multiple This setting is not support in this model

Sessions

F4 Comm SETUP Menu

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

F5 Misc SETUP Menu

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Wprt Intensity Normal, blank , dim, blank/dim.

Block End Causes the terminal to send a block of data to the computer with a line terminator as

an ASCII US character and block terminator as an ASCII CR character (US / CR), or

with line terminators as ASCII CR and LF characters and the block terminator as an

ASCII ETX character (CRLF / ETX).

Wprt Reverse Sets the write-protected characters to appear in reverse

(dark characters on a light background).

Wprt Underline Sets the write-protected characters to appear underlined.

Ptr Baud Rate Sets the SERIAL 2 port baud rate to 75, 150, 300, 600, 1200, 2400, 4800, 7200, 9600,

19200, 38400, 57600, 76800, 115200, 230400, 460800.

Ptr Data / Through the SERIAL 2 port ,the terminal to send and receive 8-bits data with one stop bit

Stop Bits or two stop bits, or 7-bits data with one stop or two stops bits.

Ptr Parity Causes the terminal to send the data to the SERIAL 2 port with none, odd, mark, even,

or space parity.

Ptr Xmt None, DSR, Xon / Xoff, Both .

Hndshake

Ptr Rcv None, DTR, Xon / Xoff, DTR/Xoff .

Hndshake

P.18