Austin Hughes Electronics NCP-1716 : User manual : Page 21

Personality Preset with VT-100, changing the parameter will cause the local acess console

malfunction

Scroll Speed Sets the display scroll rate to Jump (the rate data is received), Smooth-8 (eight lines

per second), Smooth-4, Smooth-2, or Smooth-1.

Rcvd CR Causes the cursor to move to the beginning of the current line (CR) or the beginning of

the next line (CRLF) when the terminal receives an ASCII CR.

Enhance Allows the terminal to recognize an enhanced set of codes when the terminal is not in

the native personality.

Auto Scroll Causes the data to scroll up a line when the cursor moves past the last line of the

page.

Monitor Causes the terminal to display symbols for escape sequences and control codes

without acting on them. (Test Feature)

Status Line Sets the top line of the screen as the status line.

End of Line Causes the cursor to move to the start of the next line when additional characters are

Warp entered at the end of a line.

Attribute Sets display attributes to be assigned to each character as it is entered (Char), to be

active to the end of the line (Line), or to be active to the end of the page (Page).

Xmt Limit Causes the terminal to send data through the HOST port as fast as the baud rate allows

(None), or at a maximum rate of 60 cps or 150 cps. In older systems limiting character-

rate is necessary to prevent loss of data.

Language Sets correct terminal operation for the language of the keyboard connected to it: US, UK,

Danish, German, Spanish, Swedish, Norwegian, Italian, French, Belgian, Swiss/French,

and Swiss/German

Key Repeat Off, 1, .... ,8 8 different repeat rates after a key has been depressed for about 1/2

seconds.

Margain Bell Sets the terminal’s bell to ring when the cursor reaches the column where the bell is set

(default is column 72 in 80-column mode or 124 in 132-column mode).

Keycode Sets the terminal to send normal ASCII characters (ASCII) or PC-type scan codes for

every key up / down (Scan). Scan is required for the PC Term personality.

Keyclick Sets the terminal to sound a muted beep each time a key is pressed or repeated.

NRC Sets the terminal to have national replacement character functional.

Bell Volumn Off, 1, 2, 3 (3 different volume)

Num Start Off / On when the terminal power on, this ﬁ eld determines whether the numeric pad

starts as Numeric (NUM On) or Function (NUM Off).

2.4 Changing Operating Parameters Chapter 2

F2 General SETUP Menu

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

F3 Keybd SETUP Menu

------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

P. 17