User manual

P. 13
2.3 Confi guring the Local Console Chapter 2
Saving and exiting SETUP
The fi rst menu seen when entering SETUP mode serves as a directory to the other SETUP menus. When
you depress
F12 to exit Setup, you will return to this main directory and be given the option of saving your
selections.
The highlighted fi eld at the right of the screen gives you the choice of saving or not saving parameter changes
in the nonvolatile memory before returning the terminal to the normal operating mode. If you don’t save your
setting before you leave the SETUP mode, any new selections will be lost when you power down the console
terminal drawer.
To save your SETUP selection, depress the
Spacebar to change the save fi eld at the right side of the screen
from
NO to YES before exiting SETUP.
Depress
F12 to exit SETUP mode and return to the normal display mode.
Entering SETUP
Hold down the Alt key and then depress the Esc key to enter SETUP mode.
When you enter SETUP mode, any text on the screen temporarily disappears, and the main SETUP directory
appears. When you leave the SETUP mode, the main SETUP directory disappears, and any text that was
on the screen reappears.
F1
Disp
Setup
( F1-F11 Selects menu; Shift+Esc sets defaults )
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Save ?
( SPACE toggles )
F9
Lan
F10
Colr1
F11
Colr2
F12
Exit
F7
Fkeys
F8
Ansbk
F3
Keybd
F4
Comm
F5
Misc
F6
Tabs
F2
Genrl
Switch on the power on the rear of NCP-1716.
(It takes about 60 seconds to initialize the device. Please do not input any key while initalize the device)
FDX 1-1
Caution: Scroll lock must be off for accessing setup menu by “Alt + Esc” key