Tourer Black Installation Manual

1300 663 868 | [e-mail] | aussietraveller.com.au
BRISBANE SHOWROOM: 11-15 Oasis Court, Clontarf QLD 4019 | MELBOURNE SHOWROOM: 235 Barry Road, Campbellfield VIC 3061
6. Hold the fabric in position on top of the AFK at the gap in
middle of the two sections with one hand and tighten the
locking cam handles with the other hand. Ensure the fabric is
fully secured at the gap between the two sections of the AFK.
Refer to Diagram 4B.
7. The outside edges of the fabric should now be securely
clamped with minimal deflection in the line of the fabric i.e,
the fabric should not be pulled down or lifted up at the points
of entry and exit of the AFK.
Refer to Diagram 5.
8. The walls can now be attached - Clip the wind skirt to the
bottom of the van. Slide the long side wall through the pull
strap sail track of the roller. Ensure the roller is positioned at
approximately 9 o’clock (left end) or 3 o’clock (right end). The
ends of the wall should fall in line with the AFK’s.
9. Slide the two end walls into the sail track on the inside of the
AFK. Start from the gap in the centre of the AFK and slide the
wall back towards the van and the other end forward towards
the roller.
10. To seal the end walls to the van, 2 returns are supplied, one
for each end. Slide the return (touch tape to the outside) up
the vertical sail track on the side of the van wall and fix the
“S” hook into the wall bracket. Slide the return down the sail
track on the wind skirt and press the end wall and return
touch tape together.
11. Zip the outside edges of the end walls to the long side wall
and position the two legs provided into the holes drilled in the
roller on the outside edges of the walls. Touch tape the walls
to the legs.
12. Peg the legs and the walls securely to the ground.
13. If additional bracing is desired for the walls extra poles can
be added and touch tape pole ties sewn in to the walls. The
poles are located on the outside for the long side wall and on
the inside for the front and rear end walls. Holes are drilled
in the roller to accept the long side wall poles and fitting AFK
Pole Brackets will accommodate the front and rear end wall
poles.
Fit pole end into wall bracket on side of van.
Extend AFK and fit spigot into hole in roller.
Fully extend AFK
Tighten knurl knob
Locking cam handles
Diagram 4 - Fit pole end into wall bracket
Diagram 4A -
Extend AFK & fit spigot end into hole in roller
Diagram 4B
Diagram 5