WDH-610HE WARNING / CAUTION CAUTIONS DESCRIPTION OF COMPONENTS FUNCTION EXPLANATION OPERATING INSTRUCTIONS EMERGENCY CONTINUOUS DRAINAGE MAINTENANCE / TROUBLESHOOTING
WARNING Do not fold the power cord as shown below. Make sure the plug is placed fully & firm into the socket. Do not use multiple sockets as shown below. Make sure the plug is clear. After turning the unit off, please take plug out of the socket. Do not have wet hands when connecting the power plug. If the power cord on this unit is damaged it must be replaced by the manufacturer, it's service agent or qualified persons in order to avoid a hazard.
CAUTIONS Do not pull the power cord, which may break and cause danger. Do not use insect, oil or paint spray around the machine. They might cause damage to the plastic parts or start a fire. Do not place the machine on uneven ground. This may cause shaking, noise and leakage of water. Keep the unit 20cm away from the wall to dissipate the heat properly. It is dangerous to put anything into the machine. Close all windows and doors to assist with the efficiency of removing moisture.
DESCRIPTION OF COMPONENTS CONTROL PANEL MOIST AIR INTAKE HANDLE DEHUMIDIFIED DRY AIR VENT AIR FILTER DRAIN BUCKET FUNCTION EXPLANATION CONTINUOUS CONTINUOUS 40% 50% 60% When the bucket is full of water,the dehumidifier will stop operating automatically and the bucket full light will be ON. -3- BUCKET FULL DEFROST The light is ON when the dehumidifieris in operation.
OPERATING INSTRUCTIONS Start Operation 1) Ensure that the unit is connected to the power socket. 2) Make sure the water tank is placed in proper position. (When plugged in for the first time the full tank lamp may light up. If so, just pull out the water tank then push it back to the proper position.) BUCKET FULL DEFROST 3) Press the power control to turn on the machine. Press to select humidity setting. 4) If the indoor humidity is over the set humidity, the machine will start removing moisture.
CONTINUOUS DRAINAGE The function of continuous drainage can be started in the following steps when there are good conditions for drainage near the dehumidifier. 1. To save having to periodically empty the water tank, this unit can be configured for continuous drainage. You can use a PVC hose to drain out the water - use hose with inner diameter of 13mm. Drain hose Back of the unit Continuous drainage outlet 2. Remove drain cap of the drainage outlet. Drain cap Drain hose 3.
MAINTENANCE Air filter cleans the dust and impurities from the air which may hinder the dehumidifying function, these should be regularly cleaned. The filter is located behind the rear grill and should be pulled outwards from the top to remove. Clean with a vacuum cleaner or wash it with clean water and dry with a dry cloth. Replace filter and continue to operate the dehumidifier. TROUBLESHOOTING Contact Ausclimate. Contact Ausclimate. Contact Ausclimate. Seek Ausclimate advice.
SPECIFICATION WDH-610HE 195 W 315 x 467 x 194 mm 9.5 kg If the power cord on this unit is damaged it must be replaced by the manufacturer, it's service agent of qualified persons in order to avoid a hazard This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them from using it safely. Children should be supervised to ensure that they do not play with the appliance.
