User's Manual

ManualsBrandsAurum Electronics ManualsElectronicsWireless Handheld Screen Receiver

AEC-711C Wireless Handheld Screen Receiver

I. OVERVIEW OF AEC-711C

II. ASSEMBLY INSTRUCTION

1. Install 3pcs NI-MH rechargeable batteries to the battery compartment with its polarities

matched.

Note:

- This receiver can also be powered on by adapter (DC 6V 1.5A).

- The rechargeable battery will be charged after the adapter is plugged in, and the charge

indicator lights up during charging and will turn off after a full charge.

- A full charge will take about 6 hours, which can power the receiver for about 4 hours

continuously.

- You are recommended to have the battery fully charged before its first installation to optimize its life.

- Do not burn or disassemble the rechargeable battery.

- Do not short-circuit the battery, it may cause fire or electric shock.

2. Push the power switch to ON position.

Battery case

Rechargeable

battery (inside)

LCD

LCD/TV Button

MENU Button

OK Button

Channel Button

Buzzer

Antenna

LED indicator

Power switch

Video Output

Power Socket

Holder

View Button (1/4)

(Single/Quad)

Summary of content (4 pages)

PAGE 1
AEC-711C Wireless Handheld Screen Receiver I. OVERVIEW OF AEC-711C Antenna Holder LCD LED indicator LCD/TV Button Power switch MENU Button OK Button Video Output Battery case Channel Button View Button (1/4) (Single/Quad) Buzzer Power Socket II. ASSEMBLY INSTRUCTION 1. Install 3pcs NI-MH rechargeable batteries to the battery compartment with its polarities matched. Note: - This receiver can also be powered on by adapter (DC 6V 1.5A).
PAGE 2
3 . Set the channel of receiver same as that of fitting by pressing the channel button continuously, and the pictures are displayed on the monitor/TV. - Press “MENU Button” then press Channel Button to select “MONITOR” and press “OK button”. - Press “Channel Button” to select ”Pair Cam” and then press “OK button”. - There is ”1 2 3 4” shown on the LCD, to select which number of channel you want to set up this fitting.
PAGE 3
IMPORTANT OPERATION OF WIRELESS HANDHELD SCREEN RECEIVER 1. LCD image display： push view button「1/4」for image display -Single View： single CAMERA view (initial image) display image from one camera at one time This is only for connecting 1 CAMERA. For connecting several CAMERAS, make sure to return to quad-view after finishing setting in single view.
PAGE 4
Under AUTO mode, single view will return to quad-view automatically 20 seconds later；under MENU mode, please switch from single view to quad-view by manual. Under MENU mode, if switch to single view, there will no display on the screen if other sensor lights detect motions. Looping function, 4 CAMERAS display single view on the screen in order.