Installation guide

PCI-SB StarFabric PCI Interface Card Installation Guide C-13
Using the PVX Utility
Debug Commands & Descriptions
Table 9 describes common debug commands supported for the PVX Utility. Refer to StarGen user docu-
mentation for a complete list of supported commands.
TABLE 9. Common Debugger Commands for StarFabric Devices
Command Parameters Description
dis(cover) None Discovers and initializes all reachable
devices and components attached to
the StarFabric.
mem
• -r[blsld] start_address [end_address]
• -w[blsld] start_address[end_address]
value
• -ls
address_of_link_state_entry_to_display
• -dump start_address[end_address]
• -fill start_address [end_address] value
Reads and writes memory space, dis-
plays link state table entry, and
dumps memory contents.
io
• -f[blsd] start_address[end_address]
• -w[blsld] start_address[end_address]
value
• -dump start_address[end_address]
• -fill start_address [end_address] value
Reads I/O space, writes to I/O space,
dumps I/O contents, and fills I/O con-
tents.
graph -show Shows all devices and components
attached to the primary PCI bus in list
form.
test None Executes a diagnostic test on the local
StarFabric card.
help None Launches online Help file.
log [filename.ext] Turns on logging to a file.
unlog None Turns off logging.