Installation guide

Installing the PCI-SB StarFabric® PCI Interface Card
3-22 PCI-SB StarFabric PCI Interface Card Installation Guide
For Solaris x86...
1. Type sysdef -d at the (shell) system prompt, as shown in Figure 34.
FIGURE 34. Checking Connectivity for Solaris x86
Node 'pci', unit #6
Node 'pci', unit #7
Node 'AURA,oregano', unit #1 (no driver)
Node 'pci125c,101', unit #-2 (no driver)
Node 'pci125c,101', unit #-3 (no driver)
Node 'AURA,oregano', unit #4 (no driver)
Node 'pci', unit #8
Node 'AURA,oregano', unit #5 (no driver)
Node 'AURA,oregano', unit #6 (no driver)
Node 'AURA,oregano', unit #7 (no driver)
bash-2.03# sysdef -d
Node 'SUNW,Ultra-60', unit #-1
Node 'packages', unit #-1 (no driver)
Node 'terminal-emulator', unit #-1 (no driver)
Node 'deblocker', unit #-1 (no driver)
Node 'obp-tftp', unit #-1 (no driver)
Node 'disk-label', unit #-1 (no driver)
Node 'SUNW,builtin-drivers', unit #-1 (no driver)
Node 'sun-keyboard', unit #-1 (no driver)
Unit 6 is the Host bridge interface.
Unit 7 lists the bridge for the first
four slots. And Unit 8 lists the
bridge for the next three slots.
The remote device appears as
multi-bridge PCI units followed by
the user cards installed.
PCI slots on the primary bus
appear, first.