Installation guide

Installing the PCI-SB StarFabric® PCI Interface Card
3-16 PCI-SB StarFabric PCI Interface Card Installation Guide
Step 6 - Installing Hardware Drivers
For the Linux or Solaris x86 OS: No driver installation is required. Proceed to
Step 7, on page 3-21 to complete the installation.
For Microsoft Windows OS: After powering up the local device, Windows
automatically detects the PCI-SB card installed in your device and runs a wiz-
ard to help you install a device driver for the new hardware.
Follow these steps to select a driver:
Step 1. Insert the CD-ROM that shipped with your PCI-SB card in the CD-
ROM driver of the computer and click Next as shown in Figure 28.
FIGURE 28. Select Next to Install New Hardware
Click Next to
Con
tinue
Note: The following examples
are taken from MS Windows 98
Operating System. Your screens
may appear differently.