Installation guide

Installing the PCI-SB StarFabric® PCI Interface Card
3-4 PCI-SB StarFabric PCI Interface Card Installation Guide
Inspect the PCI-SB card
Your PCI-SB card is configured for Root Bridge operation by default at the factory.
If Root Bridge is the desired operation mode, just visually inspect the card to make
sure it is configured as shown in Figure 18.
FIGURE 18. Factory-Default DIP Switch Settings
PCI-SB card DIP
Switches should be con-
figured as a Root Bridge
by default
RJ-45 port connectors
All DIP switches are set to
Down or Off position for
Root Bridge operation.